Connector fabrication: 3.5 hours

Terminated GTX45R RS332 to GSU25 J251 and GDU460 P4602 connectors.

GAD27: 3.7 hours

Wired GAD27 TB273. Continued installing wiring to fuse blocks

Wiring: 4.6 hours

Verified connector pins on GSU25 J251, GDU460 P4601. Quickly realized I needed a way to document what has been verified. It’s one pin at a time which pays well as I already found reversed wires on the RS232.

Began routing wiring to fuse blocks, labeling, and crimping fast on connectors. Installed flap power and ground wiring and GMC307 ground wiring.

CAN bus: 2.7 hours

Finished CAN bus install glad that’s over. Began routing wires.

Wiring: 3.7 hours

Ran RS232 to GMC307. Finished GDU460 P4601 assembly. Began assembly of GMC307 connector.

Installed click bonds to gear tower brace.

CAN bus and connectors: 3.3 hours

Continued CAN bus assembly. Added RS232 wire to GSU25 and GDU460 connectors. Began fabricating GDU460 connector.

CAN bus: 3.0 hours

Heat shrink arrived. Continued CAN bus assembly. GAD27 to GPS and comm radio.

Cut out instrument panel for flap switch.

CAN bus wiring: 2.0 hours

Continued fabricating the CAN buss between the GEA24 and GAD27. Ran out of heat shrink label tubing so on hold again. Finished constructing the GEA24 J241 connector.

Spent some time finalizing panel switch layout.

Garmin wiring: 1.4 hours

Started building connector harness between GAD27 and GEA24. Had some techical difficulties so I’m on hold until I hear back from Garmin.

Subpanel wiring: 3.3 hours

Began cutting wires to length, labeling and crimping connectors. Not a lot of room and my back is not happy. Have to take frequent breaks. Found three wires that are too short. Will have to rerun longer ones when I’m in the mood for a good challenge.