Installed banjo fittings to remaining brake lines.
Installed rod ends to flap drive rods.
Applied non skid to forward baggage shelf and aft baggage bulkhead.
After the paint dried I installed blind rivets to complete the seat frame assembly. Center section is complete. Will finish install of completed parts after wiring is finished.
Finished priming parts then painted seat frame, aft seat top, and instrument sub panel.
Sanded and primed aft seat top and and stiffeners. Continued sanding empennage fairing.
Applied proseal to elevator and rudder tips. Sanded skim coat and added micro to the aft seat top low spots.
Match drilled, trimmed, sanded, and applied epoxy skim coat to aft seat top.
Fabricated wingtip stiffeners using a CPVC pipe cut in half as a mold. Glassed up two layers then filled the center with flox. Slightly heavier than I wanted but stiff enough.