Continued riveting left outboard bottom skin, almost done. Plenty of difficult riveting. Had to replace 13 rivets due to poor bucking bar control.
Tech advisor had a look over of my work.
Riveted bottom inboard skin to left wing. Started riveting outboard skins. Very tough riveting and slow going.
Attached scat tube to NACA vent.
Fabricated and installed nav light connector brackets.
Added adel clamps to wing wire bundles.
Installed wing NACA vent housing to bottom wing skin and secured with proseal and soft rivets.
Made a stainless mesh screen and prosealed to vent to keep the bugs at bay.
Finished installing pitot heat pin connectors. Ran and secured right wing VOR antenna coax.
Completed wing wiring, ready for inspection and then I can rivet on the bottom skins.
Completed roll servo harness construction and installed in right wing. Turned out pretty good just hope it works!
Riveted Coax support brackets to ribs.
Began constructing roll servo harness.