Fabricated aileron stops out of nylon bushings. Sanded and filled nav light housings with micro fill.
Fabricated wing tip hinge pin retainers.
Sanded wing tip edges and edge prepped tip ribs.
Marked rivet holes on wing skins.
Made final cuts and riveted hinges to both flaps. Ready to install on wing.
Marked wingtip lense screw positions. Sanded wing tip seams flush.
Laced what I could of the right wing wiring.
Cut out and final shaped right nav light lens.
Two days work 5/7-5/8/15.
Traces cutout lines and trimmed left nav light lens.
Fabricated wing wire clamp supports.
Countersunk right flap brace and installed flap hinge pin retainer.
Adjusted left aileron pushrod to proper lenght.
Laced some of the wires on the left wing and ran wires for the right wing. Fixed a few bad rivets match drilled right wing skins to flap brace. Deburred and dimpled remaining skin holes.