Sanded aft edge of frame and added additional micro to cover air pockets. Sanded flox flange smooth. Fabricated 3/16 bushings as an engine mount hole guide.
Added more micro to flange and top of canopy frame.
Added miro to aft edge of frame to fill in gaps.
Sanded canopy flange edge for bonding later. Just about ready to prime and paint. Began drilling firewall for engine mount.
Sanded flox flange then added and sanded micro to aft side of flange.
Drilled 1/4″ holes with unibit on canopy. All holes drilled with regular #30 well used bit, no cracking issues at all. Outside temp around 85-90 degrees.
Sanded flox flange and added addotional flox.
After adding mold release to canopy flox flange was applied to frame.
Match drilled canopy to frame, no cracks lots of sweating!
Trimmed aft end of canopy frame. Sanded all frame and canopy edges. Marked drill locations on frame flange. Installed canopy in position for driling.