Wings and fairings: 4.0 hours

Secured AOA/ pitot lines to click bond.

Trimmed flanges and final sanded upper gear leg fairing edges.

Verified right wing connector pins.

Replaced three bad rivets on left wing.


Flap drive rods and wing root connectors: 2.4 hours

Drilled to 1/4 and reduced OD of flap rod end bearing retaining washers then installed on flaps. Now the rod ends are captured in case of bearing failure.

Right flap inboard edge is giving me spacing issues so I had to massage the edge into position.

Test fit wing root Deutsch connectors. Found two wires with pins instead of barrels so I fixed those.