Avionics & baggage floor: 4.4 hours

Fabricated extended forward baggage floor. I decided to use the lower compartment to mount the GPS20A and the GAD27. My plan is to mount the ECU’s and the GEA24 behind the panel so I can run the wires along the top skin behind the forward baggage door brace to the engine.

My mock up. Not much room in an RV8 but this should work. I wanted my ECU’s in a relatively cool area with wire routing as separated as possible to negate any failure effecting the other system. Only took me 3 days to figure out the placement. I will probably relocate the avionics ground bus to the lower bulkhead. I’m sure I will change it another twenty times.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s